Product Overview

Description
    • PRODUCT OVERVIEW


      Ultra-Compact Waterproof 4-Channel Full-Range Amplifier with Bluetooth 5.1 Receiver Built-In

      The NXL-N4BT takes a high-powered DS18 amplifier and integrates Bluetooth 5.1 streaming for full-range audio performance and wireless control in a sealed, IPX67-rated chassis.

      4 Channel Power
      With up to 1800W Peak, 4 x 100W RMS @ 4Ω, and 4x150W RMS @ 2Ω: this amplifier pushes full-range audio across your mids and highs leaving the perfect amount of headroom. Bridge to 2x300W RMS @ 4Ω for more flexibility in custom setups.

      Seamless Bluetooth Streaming
      Bluetooth 5.1 lets you stream directly from your phone or device with zero signal loss. With support for SBC/AAC codecs, 24-bit/48kHz audio, and A2DP 1.3.1, this amp delivers clean signal and rich fidelity wirelessly.

      DSP-Level Control with Selectable Crossover
      Fine-tune your output with built-in HPF, LPF, or Full range crossover settings, adjustable between 40–500Hz. Power components, coaxials, or a small sub with an amp that adapts to your system.

      Marine Tough
      Only 7.87” long and under 1.6” tall, the NXL-N4BT fits in gloveboxes, under seats, side panels: anywhere space is tight. And with thermal, overload, short circuit, and voltage protection built-in, you’ll stay powered safely on any terrain.

      Wirelessly control your marine audio with DS18’s NXL-N4BT!

      GENERAL SPECS

      SKU
      NXL-N4BT
      Total Watts (Peak)
      1800W
      RMS Power @ 4 ohm
      4 x 100W
      RMS Power @ 2 ohm
      4 x 150W
      RMS Power @ 4 ohm Bridge
      2 x 300W


      AUDIO

      Frequency Response
      20Hz-20KHz
      Signal to Noise Ratio 1W @ 4Ω
      90dB
      Total Harmonic Distortion (THD)
      0.1%
      Low Level Input Range
      200mV-5V
      Selectable X-Over
      HPF/LPF/FULL
      X-Over Filter Range
      40-500Hz
      Bass Boost Range
      No
      Infrasonic Filter
      No


      BT SPECS

      Bluetooth Name
      DS18 NXL-N4BT
      Version
      5.1
      Services
      Audio Stream
      Audio Protocols
      A2DP1.3.1
      Audio Codec Supported
      SBC / AAC
      Sample Rate
      48k/bit
      Bitrate
      SBC 328kbps / AAC 576kbps
      Bitrate Depth
      24bits
      Range
      20Hz - 20kHz


      FEATURES

      Amplifier Class
      Digital
      Amplifier Type
      Stereo Full Range
      Number of Channels
      1
      Minimum Impedance
      2 Ohms (Stereo / 4 Ohms Bridge)
      LED Indicator
      Power / Protection
      Power Input Size
      Wired 8Ga OFC
      Fuse Size
      25A
      Thermal Protection
      Yes
      Overload Protection
      Yes
      Waterproof Rating
      IP67


      MEASUREMENT

      Overall Length
      7.87" / 200mm
      Overall Wide
      3.67" / 93.4mm
      Overall Height
      1.56" / 39.8mm
      Heatsink Length
      7.16" / 182mm
      Gross Single Unit Weight
      2.8Lb / 1.3Kg

Free shipping on orders $100+

FAQs

Please read our FAQs page to find out more.

RMS vs. MAX power — which number do I actually care about?

RMS is what your gear handles continuously; MAX is the short burst it can survive without complaint. Match your amplifier's RMS output to your speakers' RMS rating — sizing off the MAX number is how magic smoke gets released.

What does the IP65 rating on DS18 marine gear actually mean?

It's dust-tight and rated against low-pressure water jets from any direction — built for spray, rain, and the occasional wave over the bow, not for full submersion. If something's going somewhere it could sit underwater, that's a different conversation entirely.

How do I match an amplifier to my speakers without guessing?

Add up the RMS rating of everything the amp will power, and pick an amp whose RMS output (at your speakers' impedance — usually 4-ohm) lands close to that total. Undersized is thin sound; wildly oversized is a fast way to blow a voice coil.

Can I mix marine-grade gear into a standard car audio setup, or the reverse?

You can run marine-grade gear in a car — it's just over-built for that environment, no downside besides cost. Running non-weatherproof car audio gear in an open UTV or boat is the direction that causes problems.

What gauge wiring kit do I need?

It scales with your amp's power draw and the length of the run — DS18's OFC kits come in 4-gauge and 8-gauge for a reason. Undersized wiring on a high-draw system is a voltage-drop and heat problem waiting to happen; when in doubt, size up.

Didn’t find your answer?

Don't hestitate to contact us